DriSteem VAPORMIST Specifications download pdf (Page 33)

%3*45&&.7BQPSNJTU&MFDUSJD)VNJEJGJFS*OTUBMMBUJPO0QFSBUJPOBOE.BJOUFOBODF.BOVBMt1BHF

)VNJEJGJFSTUBSUVQQSPDFEVSF

After the system is installed and connected properly, you can begin

start-up procedures.

1. Verify that the Vapormist humidifier, controls, piping, electrical

connections, steam supply, and dispersion assembly(s) are

installed according to the following:

 t *OTUBMMBUJPOJOTUSVDUJPOTJOUIJTNBOVBM

tVapor-logic

3 Installation and Operation Manual

– Installation section

– Installation checklist

 t -BEEFSTUZMFXJSJOHEJBHSBNJOTJEFIVNJEJGJFSFMFDUSJDBMQBOFM

cover)

 t &YUFSOBMDPOOFDUJPOTXJSJOHEJBHSBNJOTJEFIVNJEJGJFS

electrical panel cover)

 t "MMHPWFSOJOHDPEFT

2. Verify that all electrical connections are secure before applying

power. (See torque requirements on Page 35.)

3. WARNING!

Make sure that all electrical covers are in place and secure before

turning on electrical power. These include the following:

 t )FBUFSUFSNJOBMDPWFSPOUBOL

 t )VNJEJmFSFMFDUSJDBMQBOFMDPWFS

4. Verify that the humidifier is mounted level and securely

supported before filling with water (see the operating weights

table in this manual).

5. Verify that the humidifier is level front to back and side to side

after it is full of water.

6. Refer to the following sections in the Vapor-logic

3 Installation

and Operation Manual:

 t 0QFSBUJPOTFDUJPO

 t 4UBSUVQDIFDLMJTUJUJTDSJUJDBMUIBUUIFJOTUBMMFSGPMMPXUIJT

checklist)

7. During start-up, do not leave the humidifier unattended.

8. Monitor humidifier operation through multiple fill cycles. The

humidifier operating status appears on the keypad/display.

9. On standard water units, water skims from the humidifier

after every fill cycle. Adjust the amount of skim by increasing

or decreasing the skim time (see the Vapor-logic

3 Installation

and Operation Manual). However, at start-up, DRI-STEEM

recommends initially running the humidifier with the factory

default setting for skim time.

Note:

The

Vapor-logic3 Installation and Operation

Manual

is a comprehensive operation

manual. Refer to it for information regarding

the following features:

t ,FZQBEEJTQMBZTFUVQBOENFOV

information

t $POUSPMJOQVUTJHOBMTBOEGVODUJPOT

t %SBJOGMVTIBOETLJNGFBUVSFT

t 4BGFUZGFBUVSFT

t "MBSNTDSFFOTBOEGBVMUNFTTBHFT

The

Vapor-logic3

manual was shipped with

your humidifier. Additional copies can be

viewed, printed, or ordered at

www.dristeem.com

WARNING!

Only qualiﬁed electrical personnel should

perform start-up procedure.

Contact with energized circuits can cause

property damage, severe personal injury or

death as a result of electrical shock or ﬁre.

CAUTION! In the event the humidifier

tank does not contain water and the

heaters are energized, turn main power off.

Operation of the heaters without water will

cause damage to the humidifier. Before

turning main power on, verify that all

wiring has been completed per the wiring

instructions in this manual and the unit

wiring diagrams.

VM-IOM-1108.pdf 33 4/21/2010 1:36:22 PM

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 47 48

Comments to this Manuals

No comments

DriSteem VAPORMIST Specifications Page 33

Comments to this Manuals

Related products and manuals for Dehumidifiers DriSteem VAPORMIST